Bucket Truck Operator Safety Training with qualifications – NH DOT – CLOSED

This bucket truck operator safety training class is focused on operations and safety training for operators and ground workers. Material covered in this course:

•     Bucket truck setup
•     The mechanics of the bucket truck
•     Daily inspections
•     Working near electricity
•     ANSI and OSHA standards
•     Proper harness/belt configurations
•     Emergency procedures
•     Proper care and maintenance
•     Suspension trauma

This training meets or exceeds all requirements of OSHA, ANSI A92.2 and your insurance company.

There will be hands-on review of the equipment. Our trainer will go over proper pre-use inspections as well as proper setup of the bucket truck on-site.  Each operator will be required to run through a variety of tasks to insure competence on the equipment.  You must qualify on the equipment you use or on equipment that is the same configuration as your equipment.  Please make arrangements to have your bucket truck on site for compliance.

For more information as to the content of this class, please view the description here.

Training Length:

• 4-5 hours safety training course
• Allow 15-20 minutes per qualification
• Recommend maximum of 12-14 attendees (7 minimum)

Use this form below to request more information about our bucket truck operator safety course. One of our staff will be in contact with you soon.

OPERATOR QUALIFICATIONS

In addition to equipment specific safety training, OSHA requires operators to be evaluated on the equipment they operate.  While this can be done by a supervisor, most of our customers prefer a 3rd party evaluation.  Operators receive a certificate as well as a wallet card which includes the make, model and serial number of the equipment they were tested on.

We offer hands-on qualification on various types of equipment including forklift, MEWP, bucket trucks and mobile cranes.  We can provide the evaluations with or without a safety training class, but recommend holding both on the same day – safety training class in the morning, lunch break, qualifications in the afternoon.

Please contact our office at 508-966-4100 or use this form below to request more information. One of our staff will be in contact with you soon.

This class has been customized to our customers needs and also includes operator qualifications.  Please let us know if you have any special requirements for your training